The L series trades size and weight for higher running speed to handle fine, low-density or mildly corrosive slurry. Models run from 20A-L to 300S-L, suited to tight installation space and mildly abrasive media; it is not a substitute for a heavy duty pump on coarse solids.
Construction, model range, wetted materials and duty limits for this series. Figures come from the charts and manuals on file; values not published are marked "per supplied documents".

Horizontal, single-stage single-suction light duty slurry pump. The L series keeps the design principles of heavy duty pumps but uses a higher-efficiency impeller. It runs faster and is smaller and lighter, suiting fine-particle, low-concentration or corrosive slurry and medium-low head, high-flow duties.
Typical coverage: bores about 25-750 mm, flow up to about 13860 m3/h and head up to about 60 m.
The industry pages behind these duties set out recommended series, wear parts and field checks.
Material follows the medium; sealing follows suction pressure and whether dilution is allowed.
Each part page lists the basic number, material options and applicable models. One basic number maps to different part numbers across frames, so check against the nameplate.

Mainly high-chrome wear alloy (A05 / Cr26 / Cr27); rubber or p…

High-chrome wear alloy, wear-resistant rubber or polyurethane:…

High-chrome wear alloy, rubber lining or wear/corrosion-resist…

Wear-resistant alloy, stainless or 3Cr13-type martensitic stee…

HT250 grey iron or QT500 ductile iron.
Excerpts that apply to this series; read the full text on the online reading page.
No. Thin wear sections and high speed lead to rapid failure on coarse abrasive duty. Use AH, ZJ or G instead.
20 is the discharge bore in mm, A the impeller or build code and L the light duty series. The model page carries the full breakdown and performance.
Yes, with the material confirmed separately. Mild acid or alkali allows corrosion-resistant metal or a rubber-lined build; strong acids and high chloride need selection against the assay.
Send the medium, particle size and solids content, flow, head, pH and temperature, plus installation conditions (pit depth or line length). For parts, add the pump model or a photo of the worn part.
We reply within one business day. You can also call +86 188 0321 2220.
Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.