Thirteen pump series and twenty-seven wetted and seal parts. Each model carries its construction, code explanation and published performance data; each part its basic number, material and matching range.
AH SERIES · HEAVY DUTYThree groups by construction: horizontal heavy duty, vertical and submersible, and special duties, covering thirteen series. Representative models are listed here; full data appears on each model page.

Workhorses for ore dressing, coal washing, ash removal and tailings, at high solids and long distances.
View models →
Sump, pit and pond duties where the pump body runs submerged and needs no priming.
View models →
Gravel and coarse solids, FGD limestone slurry, froth and shield-tunnelling mud.
View models →Values below are the first listed model of each series taken from the original charts, for range reference only. Other models of the same series are listed in the index.
| Series | Model | Capacity Q m³/h | Head H m | Speed r/min | |
|---|---|---|---|---|---|
| AH | 1.5/1B-AH | 12.6–28.8 | 6–68 | 1200–3800 | Details → |
| 2/1.5B-AH | 32.4–72 | 6–58 | 1200–3200 | Details → | |
| HH | 1.5/1C-HH | 16.2–34.2 | 25–92 | 1400–2200 | Details → |
| 3/2D-HH | 68.4–136.8 | 25–87 | 850–1400 | Details → | |
| ZJ | 50ZJ-I-A50 | 57 | 110.7 | 1480 | Details → |
| 100ZJ-I-A36 | 130 | 49.5 | 1480 | Details → | |
| DT | 40DT-B20 | 16.6 | 57.5 | 2930 | Details → |
| 150DT-A50 | 62–279 | 9.3–44.6 | 490–980 | Details → | |
| SYA / ZJE | 65ZJE-Ⅱ | 27.5–80.0 | 76.0–43.5 | 1480 | Details → |
| 80ZJE-Ⅱ | 40.0–115 | 76.0–43.5 | 1480 | Details → |
Impellers, liners, casings and shaft sleeves are organised by basic part number; the same basic number maps to different item numbers across frame sizes and can be checked against the nameplate.
Sits in the pump chamber on the shaft end and forms the flow passage toget…
Fitted on the drive side of the casing behind the impeller; with the volut…
Located in the seal chamber, passing through the stuffing box or mechanica…
On the drive side of the pump end around the shaft sleeve, assembled with …
Between the pump end and the base, in horizontal split or cartridge form.
Housed in the frame; consists of the shaft, bearings, bearing housing, sea…
A slurry pump uses a double casing: the outer shell carries pressure while the inner liner and plates form the wetted passage, so wear parts are replaced without disturbing the casing or piping. High-chrome alloy and rubber are the two common routes, chosen by particle size and pH.

Original charts and manuals are rendered as web pages and can be read without downloading; wording follows the source files, with paragraph and punctuation tidying only.
For pump selection send medium, flow, head and site conditions; for parts send the pump model, nameplate photo or basic part number.
18803212220
