Stripping down every three months wastes money and adds risk. Vibration, temperature, leakage, flow and wall thickness are enough to decide when to stop and when to keep running.
Figures here come from the charts, the basic part number index and the manuals on file. Anything without a public source is marked as per supplied documents rather than inferred.

The same pump may need half the service interval in FGD compared with a concentrator. Five measurable indicators beat a fixed three-month strip-down.
Split the checks across three levels or they will not be done in the field.
| Interval | Checks | Limit | Action |
|---|---|---|---|
| Every shift | Seal drip, vibration, noise, bearing temperature, current | No sudden change | Record and hand over |
| Weekly / monthly | Gland, foundation and pipe bolts, coupling, grease | No looseness, grease正常 | Tighten, grease, adjust gland |
| Quarterly | Impeller clearance, liner wear, sleeve | Clearance within limit, no perforation | Adjust or replace |
| Annual / overhaul | Bearing assembly, shaft, casing register, alignment | Per supplied documents | Replace as a set, re-align |
An overhaul returns accumulated deviation to datum in one pass; it is not a part-by-part replacement.
Re-check alignment: coupling radial and face deviation to the manual.
Replace the bearing cartridge as a unit to avoid press-fit damage.
Check the shaft for bending, journal wear and thread condition.
Clean casing registers and cover faces; renew all gaskets.
Renew wetted parts as a set and reset clearance for material and model.
Test run: bump for rotation, then two hours on load logging vibration, temperature and flow.
One table filled for a year gives both life prediction and a spares plan.
Check at 500 hours or three months, focusing on clearance change and the seal, then set the interval from the measured wear rate.
Above 7.1 mm/s, shut down for inspection under common bands; between 4.5 and 7.1 mm/s, increase monitoring and plan service. Confirm limits for your machine.
Short term yes, but clearance cannot return to design and the new impeller wears quickly against the old liner. It rarely pays.
Measured life hours times the number of units gives annual consumption; when intervals shorten, stock must rise with them.
For pumps, send medium, flow, head, density and installation. For parts, send model, frame code and basic number. We reply within one business day.
We reply within one business day. You can also call +86 188 0321 2220.
Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.